RC Logger RC EYE One Operations Instructions download pdf (Page 30)

11. To land the “RC EYE One” again, decrease the throttle slightly until the “RC EYE One” gravitates to the

ground. A somewhat solid touchdown on the ground is no problem and should not be corrected with

jerky throttle movements. Try to touch down where possible in vertical position (“helicopter landing”).

Avoid landing with high horizontal speeds (“airplane landing”).

12. After landing, turn off the motors (pull back the throttle lever).

13. Practice this starting procedure a few times to get a feel for the “RC EYE One”. Once you are reasonably

               



not last longer than 30 to 60 seconds each.

14. 







15. 

from the model. Only then must the transmitter be turned off. With the transmitter on, a single signal

sound will be emitted.

12. BINDING FUNCTION

The remote control transmitter and the model are coupled with a special encrypted transmitter signal. This is

referred to as “binding” of the two components that warranty widely interference-free operation. Transmitter



loss of binding. In this case the “RC EYE One” would no longer react to the transmitter signal (LED in the

model is permanently lit).

To bind your transmitter to your model again, proceed as follows:

1. Connect the battery to the “RC EYE One”.

2. 

red/green alternately.

3. Push the on/off button for more than three seconds with the transmitter switched off. The transmitter

tarts beeping rhythmically.

4. The transmitter and model scan for each other and reconcile their data. After successful binding, the



13. SWITCH TRANSMITTER CHANNEL

               



You may also need to select another transmitter channel if you experience inference from other devices with

915 MHz-technology on the channel that is set (e.g. weather stations, radio headphones, etc.). Proceed as

follows for programming another transmitter channel:

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

No comments

RC Logger RC EYE One Operations Instructions Page 30